Electronics Forum | Tue May 18 18:17:50 EDT 1999 | Scott Cook
| Looking at the full convection reflow oven market, I see two segments, high mass heater ovens (i.e. Electrovert Omniflow,...), and low mass heater ovens (i.e. Heller,...) | Did some of you guys did some testing on both types and what were your find
Electronics Forum | Wed Jul 12 08:49:38 EDT 2017 | williamaxler
I have a few LED pcb's that have an aluminum > substrate that are ridiculous to rework. They > heat-sink like crazy and I can't reflow the bad > LED's, no matter how much heat I apply. Any > suggestions on techniques or equipment to use? > I ha
Electronics Forum | Tue May 18 14:47:02 EDT 1999 | Dave F
| Looking at the full convection reflow oven market, I see two segments, high mass heater ovens (i.e. Electrovert Omniflow,...), and low mass heater ovens (i.e. Heller,...) | Did some of you guys did some testing on both types and what were your find
Electronics Forum | Fri Jul 07 09:22:17 EDT 2017 | westshoredesign
Are you reflowing them and they are coming out of the oven bad? If so, what kind of oven are you using? What kind of LEDs? What kind of solder? Mass of substrate? Have you ran a profiler through your oven and compared the plot to the solder's spec
Electronics Forum | Fri Jul 25 15:54:22 EDT 2008 | pcbbuilders
I am trying to optimize my reflow profile. i have a 5 zone oven. lead-free: for the 1st 3 zones, i am good, at about 150-200 deg for 150 seconds. during the 4th zone, i am at a temp of 200-220 for 50 seconds. during the 5th zone, i am at 220-245 f
Electronics Forum | Wed Sep 23 07:39:36 EDT 2009 | jdengler
Is it possible you are putting boards in the oven with little spacing between them and the oven is not recovering fast enough? I only say this because the 12 zone oven works but the 6 zone oven does not.
Electronics Forum | Tue Jan 22 09:25:32 EST 2013 | electronar
Dear people, we need a big favor...-.we have a heller 1500sx (5 zone top-bottom - 1 cool zone), but we miss the manual and documentation. can you please help us ..!!!
Electronics Forum | Mon Jun 18 10:11:52 EDT 2007 | dyoungquist
Almost every board/panel we build is double sided and we use an MPM SPM screen printer with no problems. The screen printer is not the cause. We have seen heavier parts fall off the first side when going through the reflow for the second side. We
Electronics Forum | Thu Mar 21 16:45:31 EDT 2013 | dyoungquist
We have been using a Heller 1707EXL (7 zones + 1 cooldown zone) for lead free (ROHS) soldering since 2007 with good results. I wouldn't go any lower than 7 heat zones though. If I may brag a bit....The IPC-7095 revision C standard was released a fe
Electronics Forum | Fri May 21 03:01:22 EDT 2004 | Nitro
I want to know the pressure of N2 in each zone in furnace. If have standard it will better.
